If you wish to contribute or participate in the discussions about articles you are invited to join SKYbrary as a registered user

 Actions

Flaps

From SKYbrary Wiki

Article Information
Category: General General
Content source: SKYbrary About SKYbrary
Content control: EUROCONTROL EUROCONTROL
Ambox content.png
The present article is under construction.
Reader enquiries are welcome, contact the editor: editor@skybrary.aero.
Ambox content.png


Description

Flaps are a high lift device consisting of a hinged panel or panels mounted on the trailing edge of the wing. When extended, they increase the camber and, in most cases, the chord and surface area of the wing resulting in an increase of both lift and drag and a reduction of the stall speed. These factors result in an improvement in takeoff and landing performance.

There are many different flap designs and configurations in use. Large aircraft sometimes incorporate more than one type, utilising different flap designs on the inboard and outboard sections of the wing. The following are descriptions of some of the more common flap designs:

  • Plain Flap - The rear portion of the wing aerofoil rotates downwards on a simple hinge arrangement mounted at the front of the flap.
  • Split Flap - The rear portion of the lower surface of the wing aerofoil hinges downwards from the leading edge of the flap, while the upper surface remains immobile.
  • Slotted Flap - Similar to a Plain Flap but incorporates a gap between the flap and the wing to force high pressure air from below the wing over the upper surface of the flap. This helps reduce boundary layer separation and allows the airflow over the flap to remain laminar.
  • Fowler Flap
  • Double Slotted Fowler Flap
Flap Types

Related Articles