If you wish to contribute or participate in the discussions about articles you are invited to join SKYbrary as a registered user

 Actions

Special

Semantic search

  • A319, en-route, Free State Province South Africa, 2008 (Synopsis: On 7 September 2008 a South African Airways Airbus A319 en route from Cape Town to Johannesburg at FL370 received an ECAM warning of the failure of the No 1 engine bleed system. The crew then closed the No. 1 engine bleed with the applicable press button on the overhead panel. The cabin altitude started to increase dramatically and the cockpit crew advised ATC of the pressurisation problem and requested an emergency descent to a lower level. During the emergency descent to 11000 ft amsl, the cabin altitude warning sounded at 33000ft and the flight crew activated the cabin oxygen masks. The APU was started and pressurisation was re-established at 15000ft amsl. The crew completed the flight to the planned destination without any further event. The crew and passengers sustained no injuries and no damage was caused to the aircraft.)
  • A320, en route, north of Marseilles France, 2013 (Synopsis: On 12 September 2013, pressurisation control failed in an A320 after a bleed air fault occurred following dispatch with one of the two pneumatic systems deactivated under MEL provisions. The Investigation found that the cause of the in-flight failure was addressed by an optional SB not yet incorporated. Also, relevant crew response SOPs lacking clarity and a delay in provision of a revised MEL procedure meant that use of the single system had not been optimal and after a necessary progressive descent to FL100 was delayed by inadequate ATC response, and ATC failure to respond to a PAN call required it to be upgraded to MAYDAY.)
  • A320, en-route, north of Öland Sweden, 2011 (Synopsis: On 5 March 2011, a Finnair Airbus A320 was westbound in the cruise in southern Swedish airspace after despatch with Engine 1 bleed air system inoperative when the Engine 2 bleed air system failed and an emergency descent was necessary. The Investigation found that the Engine 2 system had shut down due to overheating and that access to proactive and reactive procedures related to operations with only a single bleed air system available were deficient. The crew failure to make use of APU air to help sustain cabin pressurisation during flight completion was noted.)
  • A320, en-route, northeast of Granada Spain, 2017 (Synopsis: On 21 February 2017, an Airbus A320 despatched with the APU inoperative experienced successive failures of both air conditioning and pressurisation systems, the second of which occurred at FL300 and prompted the declaration of a MAYDAY and an emergency descent followed by an uneventful diversion to Alicante. The Investigation found that the cause of the dual failure was likely to have been the undetectable and undetected degradation of the aircraft bleed air regulation system and whilst noting a possibly contributory maintenance error recommended that a new scheduled maintenance task to check components in the aircraft type bleed system be established.)
  • A320, en-route, west southwest of Karachi Pakistan, 2018 (Synopsis: On 5 March 2018, the crew of an Airbus A320 in descent towards Karachi observed a slow but continuous drop in cabin pressure which eventually triggered an excessive cabin altitude warning which led them to don oxygen masks, commence an emergency descent and declare a PAN to ATC until the situation had been normalised. The Investigation found that the cause was the processing of internally corrupted data in the active cabin pressure controller which had used a landing field elevation of over 10,000 feet. It noted that Airbus is developing a modified controller that will prevent erroneous data calculations occurring.)
  • A333, en-route, south of Moscow Russia, 2010 (Synopsis: On 22 December 2010, a Finnair Airbus A330-300 inbound to Helsinki and cruising in very cold air at an altitude of 11,600 metres lost cabin pressurisation in cruise flight and completed an emergency descent before continuing the originally intended flight at a lower level. The subsequent Investigation was carried out together with that into a similar occurrence to another Finnair A330 which had occurred 11 days earlier. It was found that in both incidents, both engine bleed air systems had failed to function normally because of a design fault which had allowed water within their pressure transducers to freeze.)
  • A388, en-route, northern Afghanistan, 2014 (Synopsis: On 5 January 2014, an Airbus A380-800 en route to Singapore at night made an emergency descent and diversion to Baku after a loss of cabin pressure without further event. The Investigation attributed the pressure loss to a fatigue crack in a door skin which was initiated due to a design issue with door Cover Plates, which had not been detected when the Cover Plate was replaced with an improved one eighteen months earlier. Safety Issues related to cabin crew use of emergency oxygen and diversions to aerodromes with a fire category less than that normally required were also identified.)
  • AS55, vicinity Fairview Alberta Canada, 1999 (Synopsis: On 28th April 1999, an AS-355 helicopter suffered an in-flight fire attributed to an electrical fault which had originated from a prior maintenance error undetected during incomplete pre-flight inspections. The aircraft carried out an immediate landing allowing evacuation before the aircraft was destroyed by an intense fire.)